What you would learn in Advanced Tesla diagnostic education course?
MCU is Tesla's Media Control Unit hardware. MCU 1 was used in Model S and Model X cars following March 2018. It was used in Model 3, and Model Y was initially equipped with MCU2 and then transitioned to MCU3 at the end of 2021. The vehicles with MCU1 could change to an MCU2. MCU2 comes with Intel's Atom processor.
Status of driving
1. The power meter shows the power consumption in real-time. While accelerating, the bar fills up to the right side with gray (or white if it's dark) to indicate power is being utilized. When you decelerate (when Model Y is moving and you remove your foot from the pedal for acceleration), the bar is filled to the left and is green to indicate the power flowing into the Battery through Regenerative braking. 2. When Autosteer is on, but you haven't enabled it yet, its icon will be gray. When it's activated, the icon appears blue. 3. Currently selecting the desired drive mode: Park, Reverse Neutral or Drive. 4. Driving speed. 5. Other cars detected in the roadway (as appropriate) and so on.
Access to LAN ports
A different port will be accessible after entering Developer or Factory mode on Tegra CPU.
Diagnostic modes. Modes that are activated.
In the new firmware, the entry point to the Factory is achieved by resetting all data. The primary difference between different modes:
* Factory mode is maintained until MCU restart (Media Control Unit)
*Developer mode after reboot MCU crashes
* After you enable these modes, you'll be able to see alerts (errors) within the block
Loki diagnostic equipment. Installation of firmware, changing configurations and maps.
*You may also perform the following jobs:
Reset valetReset pin for the drive
Reset the pin speed limit
*Rail on
Read / Write Tesla car Config
Install Firmware
Install Maps, modify the map region
Devices and car parts can be redeployed.
Installing maps of navigation
*WARNING! Before installing the maps, ensure your vehicle isn't downloading or installing the firmware. Also, make sure that you can turn off the alarm. On or off.
To install maps for your car, it is necessary to connect to WiFi and wait for about 10 minutes to ensure that the car doesn't immediately download the firmware during the process of map installation.
* If a problem is installed, you should hold off until the firmware can be installed fully.
*Toolbox 2.1 offline and 3.0 online Diagnostic software.
*Toolbox 2.1 is required to be in Factory Mode to work. For vehicles with an initial date of manufacture between 2012 and February 2018.
Press the brake pedal to switch on"rail mode" ("car ignition") If there aren't keys. Click the diagnostics button. Alerts DTCs. Then, under the Panel menu, we can see all errors.
Then, go through the menu options, like Battery Brakes, Battery Controls, Thermal ( for example, we can observe what's happening when pumping coolant and de-airing your cooling process), Restraint System (For instance, setting airbag errors as well as air suspension problems. )
Content of the Course:
- Information about changing the secured configuration of the tesla
- Root access to files on the tesla system
- Keys. How to add keys, read, and how create new ones. A variety of ways
- Airbags crash reset. How do I read and reset using hardware and software
Download Advanced Tesla diagnostic education course from below links NOW!
